PRINT FLUID WATER WASHABLE beige opaque

- Low odor nuisance
- Washable with water
- Very good resolution
- Made in Germany

99.00 € 99.0 EUR 99.00 €

99.00 €

(0.00 € / Units)
  • Wavelengths

This combination does not exist.

Terms and Conditions
30-day money-back guarantee
Shipping: 2-3 Business Days

Resin Parameters:

Wavelength 405 nm Shore hardness (D): 84 Viscosity (25 ° C): 200 MPa / s Liquid density: 1.20 / cm³ Flexural strength: 58 Mpa Extensibility: 36 Mpa Elongation: 8.00% Modulus of elasticity: 2200 Mpa Shelf life: 18 months Washable resin for LCD modeling (photopolymers - synthetic resin) is optimized for the weak light of LCD displays. The efficiency is much higher than comparable resins on the market. The resin is recommended for LCD displays. It is also compatible with DLP or SLA printers. Print settings: Exposure time first layer in seconds: 15-50s Normal exposure time in seconds: 1,5-10s Precautions: Storage method: Protect from light and store at room temperature. (Sunshine can harden the photosensitive resin.) It is recommended to store the resin at an ambient temperature of 15 to 35 ° C. The lower the temperature, the higher the viscosity of the resin. Sealed storage, excessive dust, or moisture can affect print quality.



Use:

Shake well before use. Avoid using resin in places with a lot of sunlight. DO NOT rinse printed items under the tap. Please ensure these chemicals are not released into the environment. Use tubs / containers filled with water. Pour unused resin back into the original resin bottle. Also avoid leaving the resin in the tub for too long without being used, as any resin contamination could affect future printing (without having poured the resin into airtight containers or sealed it with a plastic sheet).



Post-processing:

Remove the model using the metal scraper and clean the model in the cleaning box with water to wash off the excess resin in less than 2 to 3 minutes. Then place the model in another cleaning box and clean it with water to wash off the excess resins in less than 2 to 3 minutes. The model is finally cleaned in an ultrasonic device filled with water in less than 1 to 2 minutes.After cleaning, dry the model with a dust-free cloth or an air gun.


Specifications

Wavelengths 405 nm